惠而浦抽濕機 DH1801 (CF61) 專業維修 Whirlpool DH1801 (CF61) Dehumidifier Repair HK

自助處理步驟 DIY Steps

• 檢查插蘇、電掣是否跳掣、插座有無電；Check plug, circuit breaker & power socket
• 機身側 / 底部水箱滿水浮波卡住，取出水箱重新放穩；Water tank float stuck, take out & re-install tank
• 門蓋 / 濾網蓋未關實，安全開關斷電，蓋緊再試；Filter cover not fully closed, secure cover tightly
• 長按電源鍵 10 秒重置機器。Hold power button 10s to reset unit

仍無反應：電源板、變壓器故障，需專業維修。 Still no response: Power board / transformer broken, need professional repair.

自助處理步驟 DIY Steps

• 抽出水箱，清洗內部浮球（浮波），撥動浮球看能否上下活動；Clean float ball inside tank, test movement
• 水箱滑道有灰塵阻礙，抹乾淨、確保水箱完全推入卡實；Wipe tank slide, fully insert tank into position
• 浮球卡膠、斷裂：更換浮球配件。Stuck / broken float: Replace float spare part

3. 風扇有轉，但完全唔抽濕、室內濕度不下降Fan running but no dehumidifying, humidity unchanged

• 室溫低於 16℃，壓縮機會凍結停機，屬保護；Room temp below 16°C, compressor freeze protection
• 濾網、蒸發器灰塵堵塞，拆出濾網水洗、風葉擦乾淨；Clean clogged filter & evaporator coil
• 設定濕度太高（如 65% 以上），調至 45–55%；Set target humidity to 45-55%
• 門窗大開、室外極度潮濕，關窗封門；Close all windows & doors

仍不抽濕：雪種漏、壓縮機故障，需師傅。Still no effect: Refrigerant leak / compressor failure, technician required.

4. 機身出風凍、內部結滿冰 / 霜Cold air output, heavy frost / ice inside unit

• 關機開風扇模式運行 2–3 小時自然融霜，切勿用熱水沖機內；Run fan mode 2-3hrs to melt frost naturally, NO hot water flush
• 清洗濾網，堵塞會令風量不足結霜；Clean blocked air filter
• 室溫太低，可開暖爐提升室溫；Use heater to raise room temperature
• 勿擋入風口，保持機身四周 10cm 空間散熱。Keep 10cm clearance around machine for ventilation

持續結霜：溫度感應器故障。Continuous frost: Temperature sensor defective.

自助維修重要安全守則 DIY Maintenance Safety Rules

• 所有清潔、檢查前必須拔插蘇斷電；Unplug power before any cleaning & inspection
• 機內結霜只可自然融冰，嚴禁熱水、風筒直吹；Only natural defrost, forbidden hot water / hair dryer
• 不可自行拆壓縮機、雪種管路，涉及製冷系統需專業維修；Do NOT disassemble compressor & refrigerant pipe, only certified technician allowed
• 每月清濾網、每季度清洗接水盤，大幅減少故障。Clean filter monthly, drain pan quarterly to lower breakdown rate

何時需要預約師傅上門維修 When you need professional repair service

• 漏雪種、完全不抽濕；Refrigerant leak, zero dehumidifying effect
• 壓縮機異響、無法啟動；Abnormal compressor noise, fail to start
• 主板、感應器、風扇馬達損壞；Faulty mainboard, sensor or fan motor
• 內部管路漏水、零件斷裂。Internal pipe leakage, broken spare parts