平價維修志高抽濕機，按鈕無反應抽唔到水 . 全系列支援
作者：香港駿弘電器維修公司
浏览：
发表时间：2026-07-18 22:14:34
zh
熱線：55311921 / 67645053
Hotline: 55311921 / 67645053
haolong2002@gmail.com
haolong2002@gmail.com
特大喜訊｜平價維修志高抽濕機，按鈕無反應抽唔到水，全系列支援
Special Offer | Affordable Chigo Dehumidifier Repair, Button Unresponsive / No Water Extraction, Full Series Supported
香港觀塘實體門店，可到店檢查，上門維修服務香港島、九龍、新界全區，提供20項抽濕機故障自修教程，維修全進口/國產抽濕機品牌
Physical Workshop in Kwun Tong HK, Walk-in Inspection & Door-to-door Repair for HK Island, Kowloon & NT. 20 DIY Troubleshooting Guides for all dehumidifier brands
20款抽濕機常見故障及自行處理教程
20 Common Dehumidifier Faults & DIY Repair Guide
點擊標題展開對應故障自修步驟，簡單問題可自行維修，複雜故障歡迎聯絡我哋專業維修
Click title to expand DIY steps. Simple issues can be fixed by yourself, contact us for complex breakdowns
1. 抽濕機按鈕無反應、完全無法開機（志高常見故障）
1. Buttons Unresponsive, Cannot Power On (Chigo Common Fault)
自修步驟：
DIY Steps:
- 檢查電源插頭是否鬆脫、插座有無電，更換插座測試
- 檢查機身電源保險絲是否燒斷
- 清潔控制面板按鈕縫隙灰塵、黴菌
- 斷電5分鐘重啟重置主板
- 仍無反應：控制面板/主板損壞，需專業維修更換零件
- Check loose power plug & wall socket, test another socket
- Inspect blown internal fuse
- Clean mold & dust inside button gaps
- Unplug power for 5 mins to reset mainboard
- If still broken: control panel / mainboard replacement required
2. 機器運轉但完全抽唔到水、室內濕度無下降
2. Unit Running But No Water Collected, Humidity Unchanged
自修步驟：
DIY Steps:
- 清洗內部過濾網、蒸發器灰塵堵塞
- 確認設定濕度低於室內實際濕度
- 檢查冷凍系統是否漏雪種
- 擺放位置勿貼牆，保留通風空間
- 長期無水：壓縮機故障/雪種洩漏，專業維修
- Clean clogged air filter & evaporator coil
- Set target humidity lower than room humidity
- Check refrigerant gas leakage
- Leave ventilation space away from walls
- No water at all: compressor / gas leak professional repair
3. 水箱滿水警示燈常亮，實際水箱空
3. Full Water Alarm Always On, Tank Empty
自修步驟：
DIY Steps:
- 取出水箱清潔浮球感應器水垢、黴菌
- 確認水箱完全卡緊、無移位
- 輕輕撥動浮球測試能否上下活動
- 浮球卡死則更換水箱感應配件
- Remove tank, clean limescale on float sensor
- Re-seat tank fully into position
- Test float movement manually
- Stuck float requires sensor replacement
4. 抽濕機開機幾分鐘自動斷電、自動關機
4. Auto Shutdown After Running A Few Minutes
自修步驟：
DIY Steps:
- 清潔濾網散熱堵塞導致過熱保護
- 檢查室內溫度是否過低觸發防凍保護
- 斷電重置主板消除故障碼
- 持續自動關機：溫度感應器故障
- Clean blocked filter causing overheat protection
- Low room temp triggers anti-freeze mode
- Power cycle unit to clear error codes
- Repeated shutdown: faulty temperature sensor
5. 機器運作產生巨大噪音、震動嚴重
5. Loud Vibration & Unusual Operating Noise
自修步驟：
DIY Steps:
- 將機器擺放平整、墊防滑墊減震
- 檢查風扇葉是否卡灰塵、異物
- 清理風扇軸心雜物
- 金屬撞擊聲：壓縮機支架老化需維修
- Place unit flat, add anti-slip mat
- Remove dust & foreign objects from fan blade
- Clear debris from fan shaft
- Metal banging sound: aging compressor mount
6. 抽濕機漏水、地面經常積水
6. Water Leakage, Floor Flooding
自修步驟：
DIY Steps:
- 疏通底部導水盤水垢堵塞出水口
- 檢查水箱密封圈老化滲水
- 確認機身向前微傾利於排水
- 外接排水管彎折、堵塞會倒流水
- Unclog limescale drain tray outlet
- Check aged rubber tank seal
- Tilt unit slightly forward for drainage
- Kinked external drain pipe causes backflow leak
7. 風扇完全不轉、只有壓縮機運轉
7. Fan Not Spinning, Compressor Running Only
自修步驟：
DIY Steps:
- 斷電手動撥動風扇檢查是否卡死
- 清理風扇葉黴菌灰塵
- 檢查風扇電機供電插頭鬆脫
- 完全不轉：風扇馬達燒毀需更換
- Unplug power, spin fan manually for jam test
- Clean mold & dust on fan wheel
- Check loose fan motor wiring connector
- No rotation: burnt fan motor replacement
8. 面板顯示亂碼、錯誤故障碼無法消除
8. Garbled Display, Permanent Error Code
自修步驟：
DIY Steps:
- 完全斷電10分鐘重置控制主板
- 擦拭顯示面板背後潮濕水垢
- 檢查室溫/濕度感應器插頭
- 持續亂碼：控制面板主板損壞
- Full power cut for 10 mins to reset PCB
- Wipe damp limescale behind display panel
- Inspect humidity/temp sensor wiring
- Permanent error: faulty main control board
9. 抽濕機出風有異味、霉味、酸味
9. Musty / Sour Odor From Air Outlet
自修步驟：
DIY Steps:
- 拆洗濾網、蒸發器黴菌
- 清潔導水盤細菌積水
- 運行風乾模式半小時殺菌
- 長期異味需拆解深層清洗內機
- Remove & wash mold from filter & evaporator
- Clean bacteria buildup inside drain tray
- Run fan-only dry mode for disinfection
- Persistent odor requires full internal deep clean
10. 定時功能失效、無法設定開關機時間
10. Timer Function Broken, Cannot Schedule Power
自修步驟：
DIY Steps:
- 斷電重置機器系統時鐘
- 重新設定當前時間再開啟定時
- 按鈕接觸不良則清潔面板按鍵
- 完全無法定時：主板計時模組故障
- Power cycle to reset internal clock
- Set current time before using timer
- Clean unresponsive button contacts
- Total timer failure: PCB timing module damage
11. 壓縮機完全不啟動，只有風扇運轉
11. Compressor Not Starting, Fan Running Only
自修步驟：
DIY Steps:
- 確認設定濕度低於室內濕度
- 室溫過低觸發防凍保護，回暖再測試
- 斷電重置解除保護鎖定
- 仍不啟動：壓縮機啟動電容燒毀
- Ensure target humidity lower than room level
- Low temp triggers anti-freeze lockout
- Power cycle to clear safety lock
- No start: burnt compressor run capacitor
12. 抽濕機冷卻效果差、抽水量大幅減少
12. Weak Dehumidification, Low Water Output
自修步驟：
DIY Steps:
- 全面清洗濾網、蒸發器、冷凝器灰塵
- 關閉房間窗戶減少外界濕氣流入
- 清理機身周圍阻礙通風雜物
- 清洗後依舊差：雪種不足需要加雪
- Deep clean filter, evaporator & condenser coils
- Close windows to block external humid air
- Remove objects blocking air intake/outlet
- Weak performance after cleaning: low refrigerant gas
13. 水箱取出後機器依舊無法停機報警
13. Tank Removed But No Alarm Shutdown
自修步驟：
DIY Steps:
- 擦拭水箱位置感應金屬觸點氧化層
- 檢查感應開關是否被灰塵卡住
- 斷電重啟重置感應系統
- 感應開關損壞需更換水位感應零件
- Wipe oxidized metal tank sensor contacts
- Clear dust jamming tank limit switch
- Power cycle to reset sensor logic
- Broken limit switch needs replacement
14. 遙控器完全失靈、無法操控機器
14. Remote Control Unresponsive
自修步驟：
DIY Steps:
- 更換全新遙控器電池，清理電池彈片鏽跡
- 手機相機測試紅外發射燈是否發光
- 擦拭機身紅外接收窗口灰塵
- 接收頭損壞需要維修更換接收器
- Replace remote batteries, clean rusted terminals
- Test IR emitter via phone camera lens
- Wipe dust on unit IR receiver window
- Broken IR receiver requires component swap
15. 機身外殼結霜、蒸發器嚴重冰塞
15. Evaporator Coil Frost / Ice Blockage
自修步驟：
DIY Steps:
- 關機靜置完全融冰後清潔濾網
- 室溫低於16度容易結霜，提升室溫再使用
- 確保風扇風量充足不堵塞
- 持續結冰：除霜溫度感應器故障
- Power off & fully melt ice before cleaning filter
- Avoid operation below 16°C room temperature
- Ensure unobstructed airflow
- Permanent ice: faulty defrost temperature sensor
16. 抽濕機耗電量異常偏高、電費急升
16. Abnormally High Power Consumption
自修步驟：
DIY Steps:
- 清洗堵塞濾網減少壓縮機負荷
- 設定合適濕度，勿長時間開強力抽濕
- 房間密封減少室外濕氣持續侵入
- 機器老化壓縮機效率下降需維修檢查
- Clean clogged filter to reduce compressor load
- Set reasonable humidity level, avoid max mode all day
- Seal room to block continuous humid air intake
- Aging compressor causes energy efficiency drop
17. 外接自動排水管不出水、排水中斷
17. External Drain Pipe Blocked, No Auto Drain
自修步驟：
DIY Steps:
- 拆除排水管沖洗內部水垢堵塞
- 排水管全程向下傾斜，不可彎曲抬高
- 清理機身排水口雜物堵塞
- 內置排水泵故障會無法自動排水
- Disconnect & flush limescale from drain tube
- Maintain downward pipe slope, no upward bends
- Clear debris at unit drain outlet
- Broken internal drain pump stops auto drainage
18. 開機後面板完全無顯示、無任何燈光
18. No Display Lights After Power On
自修步驟：
DIY Steps:
- 全屋斷電檢查插座電壓、電路跳掣
- 拆機檢查內部主保險絲是否燒斷
- 電源變壓器燒毀會完全無供電
- 電源板損壞需要更換電源模塊
- Check tripped circuit breaker & wall socket voltage
- Inspect blown main internal fuse
- Burnt power transformer cuts all supply
- Damaged power board requires module replacement
19. 風速切換失效，只能固定單一風量
19. Fan Speed Adjustment Broken, Fixed Airflow Only
自修步驟：
DIY Steps:
- 斷電重置控制面板邏輯
- 清潔風速切換按鈕接觸點灰塵
- 檢查風扇調速電容是否老化
- 調速模組故障需更換風扇控制零件
- Power cycle to reset control logic
- Clean dusty fan speed button contacts
- Inspect aging fan speed capacitor
- Broken speed regulator component replacement
20. 機器間歇性斷斷續續運轉，時開時停
20. Intermittent On-Off Random Operation
自修步驟：
DIY Steps:
- 檢查電源線內部斷線、插頭接觸不良
- 清潔溫度/濕度感應器消除誤觸保護
- 機身散熱不良過熱間歇保護停機
- 主板接線氧化鬆脫會間歇斷電
- Check internal broken power cord & loose plug
- Clean humidity/temp sensor to stop false protection
- Poor ventilation triggers intermittent overheat shutdown
- Oxidized loose PCB wiring causes random power loss
