aMAGIC AWC wine cooler repair service Hong Kong. Fix temperature error codes E1 HH LL, no cooling, no power, water leaking, frosting issue. On‑site service for HK Island, Kowloon, New Territories.
English:Mainly caused by burnt power board, blown fuse or power supply fault. First check wall socket. If power supply normal but unit dead, need technician replace power mainboard, on‑site service available HK wide.
English:Common refrigerant gas leak. Compressor running but no cooling. Do not keep running the unit. Need leak test, vacuum & refrigerant recharge. On‑site service Kwun Tong, Kowloon, New Territories.
English:LL low temperature alarm. Usually short‑circuited sensor or main control board signal error. Over‑cooling & heavy frost build‑up. Check sensor wiring & replace defective parts.
English:HH high temperature alarm. Causes: door seal leak, fan not working, dirty condenser, compressor fault. First check door fully closed. If alarm persists book on‑site repair.
English:Dual‑zone wine cooler one side warm. Most common internal circulation fan motor failure. Cold air cannot circulate. Fan motor can be replaced on‑site.
English:Loud noise & vibration: worn fan motor, aged compressor rubber mount, pipe collision. Check unit level. Replace fan or adjust compressor damping if noise remains.
English:Heavy frost / ice build‑up. Defrost system error, defrost sensor fault or bad door seal. Thick frost blocks cooling efficiency. Check defrost sensor & main control board.
English:Display flickering, garbled code, temperature value jumping. Display panel fault or loose main board wiring. Check cable harness; replace display panel or main circuit board.
English:Built‑in wine cooler poor cooling. Insufficient ventilation space triggers compressor overheat protection. Keep clearance around unit. If problem persists check compressor & refrigerant.
English:Out‑of‑warranty aMAGIC AWC wine cooler repair. We fix E1 E3 HH LL error codes, no cooling, water leak, fan, compressor & sensor faults. On‑site quotation for HK Island, Kowloon, New Territories.
紅酒櫃維修標準流程|Wine Cooler Repair Workflow
Our standard on‑site repair procedure
1
客戶諮詢報障 Case Enquiry
WhatsApp /電話講解故障現象、報錯代碼,初步評估維修方向。
2
預約上門 Book On‑site Visit
約定時間,師傅到達現場做機器全面檢測。
3
檢測報價 Inspection & Quotation
找出故障源頭,講解損壞零件,報價給客戶確認。
4
現場維修更換 Repair & Parts Replacement
客戶同意後現場更換傳感器、風扇、電容、電源板、加注雪種等。
5
測試驗機 Testing & Commissioning
運行測試溫度、報警、製冷、噪音,確認故障完全排除。
6
售後跟進 After‑sales Follow‑up
完成維修,提供保養建議。
專業維修工具|Professional Repair Tools
Specialized instruments for wine cooler servicing
製冷壓力錶
雪種測試、測漏、抽真空加注
數碼萬用電表
測電源板、傳感器、電容、線路
高精度溫度測試儀
檢測酒櫃實際溫度偏差
冷媒測漏儀
偵測管路雪種洩漏位置
專業手工具套裝
拆裝面板、風扇、壓縮機零件
客戶好評成功個案|Customer Reviews & Completed Cases
Real feedback from our wine cooler repair customers