A：多數係電源板燒毀、保險絲燒斷、插頭供電異常。先檢查插座有沒有電；若供電正常機器毫無反應，需要維修師傅檢測更換電源主板，全港可上門檢測。

A：Mostly blown power board, fuse failure or power‑socket issue. Check wall socket first. If power is normal but unit dead, technician needs to inspect & replace main power board. Door‑to‑door service available all over HK.

A：常見雪種泄漏、製冷管路漏氣。壓縮機轉但無冷氣，不要長時間開機，需要師傅做管路測漏、抽真空、重新加注雪種，觀塘、九龍、新界均可上門處理。

A：Common refrigerant gas leak. Do not keep running the unit. Technician will perform leak test, vacuum & gas recharge. Service for Kwun Tong, Kowloon, New Territories.

A：E1 代表溫度感應器故障老化。感應器讀數錯亂令酒櫃無法控溫，一般直接更換對應溫度傳感器即可現場維修。

A：E1 means defective temperature sensor. On‑site replacement of sensor will fix most cases.

A：LL 低溫報錯，多為溫度傳感器短路或者主控板訊號異常。會出現過度製冷、櫃內結厚霜，需要檢查傳感器線路及更換零件。

A：LL low‑temp error usually caused by short‑circuited temperature sensor or main board signal fault. It triggers over‑cooling & heavy frost. Need wiring inspection & part replacement.

A：HH 代表偵測到櫃內溫度過高。原因有門封漏冷、風扇不轉、冷凝器積灰散熱差、壓縮機故障。先檢查門有沒有關緊，仍然報警就要上門維修。

A：HH = inside cabinet overheat. Causes: bad door seal, fan dead, dusty condenser, compressor failure. Check door closed tightly; call technician if alarm persists.

A：雙溫區最常壞係內循環風扇摩打損壞，冷氣無法送到另一個溫區。風扇不轉就會出現單邊不製冷，現場可以更換風扇零件。

A：Most common fault: internal circulation fan motor broken. Cold air cannot flow to second zone. On‑site fan motor replacement service.

A：主要來源：風扇摩打磨損、壓縮機腳膠老化鬆動、管路互相撞擊。檢查是否擺放不平；噪音持續就要維修更換故障風扇或調整壓縮機避震。

A：Worn fan motor, aged compressor rubber mount, pipe collision. Check cabinet level. Replace defective fan or adjust compressor shock‑absorber if noise remains.

A：排水孔堵塞、門封膠條老化漏冷，導致櫃外同內部大量凝露滴水。先清通排水孔；膠條老化就要更換門封，解決漏冷滴水問題。

A：Drain hole blocked or worn door gasket causes condensation & dripping. Clear drain hole first; replace door seal if gasket is aged.

A：多為壓縮機啟動電容老化衰減，電容出力不穩，造成壓縮機斷斷續續工作。更換啟動電容多數可以解決此故障。

A：Aged compressor starting capacitor leads to unstable compressor operation. Replacing start‑capacitor solves most intermittent cooling issues.

A：除霜系統異常、除霜感應器故障、門密封不良濕氣持續入櫃。厚霜會阻礙製冷效果，需要維修檢查除霜感應器同主控板。

A：Defrost system error, defective defrost sensor or bad door seal letting moisture in. Heavy frost blocks cooling performance. Need inspect defrost sensor & main control board.

A：內置循環風扇摩打燒毀，就算壓縮機正常，冷氣散不出來。表現壓縮機一直轉但降溫慢，現場可更換風扇組件。

A：Burnt‑out circulation fan motor. Compressor runs but poor cooling. On‑site fan assembly replacement service.

A：顯示面板故障或者主控板接觸不良。溫度讀數跳動無法正常設定溫度，需要檢查排線、更換顯示板或者主控電路板。

A：Faulty display panel or loose main‑board wiring. Need inspect wiring harness; replace display board or main circuit‑board.

A：嵌入式機型最常見散熱空間不足，後面同兩側散熱位被封死，壓縮機過熱保護。先確保機身留有散熱空位，故障依舊就要檢查壓縮機同雪種。

A：Built‑in model often suffers from insufficient ventilation space causing compressor overheat protection. Keep clearance for heat dissipation. If fault persists inspect compressor & refrigerant gas.

A：壓縮機卡缸、啟動電容損壞。會聽到嗡嗡聲之後跳保護，機器無法進入製冷。需要師傅現場判斷更換電容或者壓縮機。

A：Compressor locked rotor or failed start‑capacitor. Humming noise then trips protection. Technician on‑site assessment for capacitor or compressor replacement.

A：aMAGIC AWC 酒櫃過保後原廠維修收費昂貴，可找專修紅酒櫃師傅，處理 E1/E3/HH/LL、不製冷、漏水、風扇、壓縮機、傳感器等故障，觀塘、九龍、香港島、新界均可提供上門檢查報價。

A：Original manufacturer out‑of‑warranty repair charge is expensive. Our technicians handle E1/E3/HH/LL error codes, no cooling, water leak, fan, compressor & sensor faults. Quotation & door‑to‑door service for Kwun Tong, Kowloon, HK Island & New Territories.