TRANSTHERM 酒櫃內風扇唔轉溫度不均｜收藏紅酒險全毀
TRANSTHERM Wine Cooler Fan Not Working Temperature Uneven

原因分析：壓縮機故障、雪種洩漏、散熱塵垢過多
用戶自檢：檢查背後散熱位是否被雜物阻擋，門有冇關實
處理/維修更換零件：清潔散熱網；雪種測漏加註；損壞需更換壓縮機

Fault: Wine cooler not cooling, temperature cannot drop. Cause: Compressor failure, refrigerant leak, dusty heat sink. Self‑check: Check rear ventilation & door seal. Repair: Clean heat sink, refill refrigerant, replace compressor if broken.

原因分析：溫度感應器老化、風扇循環異常、門封漏冷
用戶自檢：觀察門膠條是否有縫隙，內籠風扇有無轉動
處理/維修更換零件：更換溫度感應器；維修循環風扇；替換老化門封膠條

Fault: Intermittent cooling, temperature fluctuating. Cause: Aging temperature sensor, circulation fan fault, cold air leakage from door gasket. Self‑check: Check door rubber seal & inner fan rotation. Repair: Replace sensor, repair fan, renew door gasket.

原因分析：電源板故障、保險絲燒毀、電路接線鬆脫
用戶自檢：插座測試有冇電，電源插頭是否插穩
處理/維修更換零件：檢查更換保險絲；維修電源主板；重接鬆脫線路

Fault: Unit totally dead no power response. Cause: Power board fault, blown fuse, loose wiring. Self‑check: Test wall socket & power plug. Repair: Replace fuse, repair main power board, re‑connect loose cables.

原因分析：顯示面板故障、接觸線鬆動、主板供電異常
用戶自檢：重新斷電重啟 5 分鐘再開機測試
處理/維修更換零件：重新插接排線；維修或更換觸控顯示面板

Fault: Display screen black but machine running. Cause: Display panel failure, loose ribbon cable, mainboard power anomaly. Self‑check: Power off for 5 minutes then restart. Repair: Re‑seat ribbon cable, repair or replace touch display panel.

原因分析：觸摸面板受潮老化、主板控制模組損壞
用戶自檢：抹乾面板表面水氣，斷電重啟測試
處理/維修更換零件：清潔檢查排線；必要更換整套觸控面板

Fault: Touch panel no response cannot adjust temperature. Cause: Moisture‑damaged touch panel, control module damage. Self‑check: Wipe moisture off panel, power cycle. Repair: Inspect ribbon cable, replace full touch‑control unit when needed.

原因分析：門未關妥、溫度超標、故障代碼觸發警報
用戶自檢：關緊櫃門，查看屏幕有冇彈出錯誤代碼
處理/維修更換零件：排除門關閉問題；讀取故障代碼維修對應零件

Fault: Continuous beep alarm sound. Cause: Door ajar, temperature over threshold, error‑code trigger. Self‑check: Close door fully, check display error code. Repair: Resolve door‑closure issue, troubleshoot parts per error code.

原因分析：分區風扇損壞、擋風隔板移位、控溫感應器故障
用戶自檢：檢查內籠擋板有冇被酒瓶擋住出風口
處理/維修更換零件：維修分區循環風扇；更換對應溫度感應器

Fault: Dual‑zone cooler one side cold one side warm. Cause: Zone fan failure, baffle misaligned, zone sensor fault. Self‑check: Ensure wine bottles not blocking air outlet baffles. Repair: Repair zone circulation fan, replace faulty temperature sensor.

原因分析：除霜系統失效、門封漏氣、濕度過高
用戶自檢：停機解凍，檢查門膠條有冇漏冷氣
處理/維修更換零件：維修除霜感應器；更換門封膠圈

Fault: Internal ice & heavy evaporator frost build‑up. Cause: Defrost system failure, gasket air‑leak, excessive humidity. Self‑check: Power‑off defrost unit, inspect door gasket cold‑air leakage. Repair: Fix defrost sensor, renew door gasket seal.

原因分析：排水孔堵塞、排水管脫落、凝水盤滿溢
用戶自檢：查看底部接水盤是否水滿，清理排水孔異物
處理/維修更換零件：疏通排水管路；重新安裝脫落排水管

Fault: Water dripping bottom, internal water pooling. Cause: Blocked drain hole, fallen‑off drain pipe, overflow condensate tray. Self‑check: Inspect water tray fullness, clear drain hole debris. Repair: Unclog drain path, re‑fit disconnected drain tube.

原因分析：壓縮機腳膠老化、風扇葉片碰殼、零件鬆動
用戶自檢：檢查酒櫃是否擺放水平，背後有冇牆面碰撞
處理/維修更換零件：更換減震膠腳；維修更換故障風扇馬達

Fault: Loud running noise & cabinet vibration. Cause: Aged compressor rubber mount, fan blade hitting housing, loose components. Self‑check: Confirm unit level, no back‑wall collision. Repair: Replace anti‑vibration feet, repair or swap faulty fan motor.

原因分析：門鉸磨損、門封膠條變形老化
用戶自檢：用紙張夾在門縫測試，紙可輕易抽出即漏冷
處理/維修更換零件：調校門鉸；更換全新門封膠條

Fault: Door cannot close tightly, pops open. Cause: Worn door hinge, deformed aged gasket. Self‑check: Paper‑slip door‑gap leakage test. Repair: Adjust door hinges, install brand‑new door gasket.

原因分析：散熱位被封死、環境溫度太高、連續長時間運轉
用戶自檢：確保機身四周預留 10cm 以上散熱空間
處理/維修更換零件：清理散熱網塵埃；改善周邊通風環境

Fault: Cabinet outer shell overheating. Cause: Blocked ventilation, high ambient temperature, long continuous runtime. Self‑check: Minimum 10cm clearance around cabinet sides & rear. Repair: Clean heat‑sink dust, improve surrounding ventilation.

原因分析：LED 燈條燒壞、燈具接線鬆脫
用戶自檢：斷電後輕搖燈帶位置，重啟測試
處理/維修更換零件：重新接駁線路；更換 LED 照明燈條

Fault: Inner LED light dead while other functions normal. Cause: Burnt LED strip, loose lamp wiring. Self‑check: Power‑off, gently nudge lamp strip then restart. Repair: Re‑connect wiring harness, replace LED light bar.

原因分析：壓縮機短路、電容損壞、電路受潮短路
用戶自檢：不要反覆重啟，避免擴大故障
處理/維修更換零件：檢測壓縮機與啟動電容，更換損壞零件

Fault: Trips circuit breaker shortly after power‑on. Cause: Compressor short‑circuit, bad capacitor, moisture‑caused short. Self‑check: Do NOT repeatedly restart unit to avoid further damage. Repair: Test compressor & start‑capacitor, replace defective components.

原因分析：溫度探頭損壞、主板訊號異常
用戶自檢：斷電重啟，觀察是否持續亂數
處理/維修更換零件：更換溫度感應探頭；檢修主控板

Fault: Temperature display flickering / inaccurate readings. Cause: Damaged temperature probe, mainboard signal error. Self‑check: Full power‑cycle reboot observe symptom persistence. Repair: Replace temperature sensor probe, inspect & repair main control board.

原因分析：櫃體封死散熱空間、通風位被傢俬阻擋
用戶自檢：檢查櫃體上下後方通風口是否被遮蓋
處理/維修更換零件：釋放散熱空間；清潔內置散熱模組

Fault: Built‑in TRANSTHERM wine cooler cooling performance drops. Cause: Enclosed zero‑clearance installation blocks ventilation, furniture covers vents. Self‑check: Check top‑rear‑bottom air‑vents are unobstructed. Repair: Free‑up ventilation clearance, clean integrated heat‑dissipation module.

原因分析：門封漏冷、設定溫度過低、感應器失效
用戶自檢：適當調高設定溫度，檢查櫃門密封
處理/維修更換零件：更換門封膠；替換故障溫度感應器

Fault: Wine cooler runs non‑stop 24‑hours. Cause: Cold‑air leakage door gasket, temperature set too low, dead sensor. Self‑check: Raise set‑point temperature, verify door sealing. Repair: Install new door gasket, swap defective temperature sensor.

原因分析：對應感應器、風扇或主板故障
用戶自檢：斷電 5‑10 分鐘重啟，看是否消除代碼
處理/維修更換零件：對應代碼排查零件，更換損壞組件

Fault: Error‑code E1 / E2 displayed. Cause: Related sensor, fan or mainboard malfunction. Self‑check: Power‑off 5‑10 minutes then reboot to clear temporary fault. Repair: Troubleshoot parts according error‑code, replace broken assemblies.

原因分析：除濕模組異常、門頻繁開關、環境濕度太高
用戶自檢：減少頻繁開門，檢查門密封狀態
處理/維修更換零件：維修控濕零件；檢查除霜系統運作

Fault: Abnormal internal humidity, wine labels get mouldy. Cause: Dehumidify module anomaly, frequent door opening, high ambient humidity. Self‑check: Minimize door‑opening frequency, inspect door seal integrity. Repair: Service humidity‑control parts, verify defrost‑system operation.

原因分析：循環風扇馬達燒毀、風扇卡到異物
用戶自檢：輕聽內籠有冇風扇轉動聲音
處理/維修更換零件：清理異物；維修或更換內循環風扇馬達

Fault: Unit hums running but zero cold air blowing out. Cause: Burned circulation fan motor, foreign object jams fan wheel. Self‑check: Listen for inner‑cabinet fan spinning noise. Repair: Clear jam debris, repair or replace internal circulation fan motor.