故障1:Vinorich 酒櫃唔製冷、溫度降不下來
Fault 1: Wine cooler not cooling, temperature cannot drop
▼
原因:壓縮機故障、雪種洩漏、散熱塵垢過多
用戶自檢:檢查背後散熱位是否被雜物阻擋,門有冇關實
處理:清潔散熱網;雪種測漏加註;損壞需更換壓縮機
Cause: Compressor failure, refrigerant leak, dusty heat‑dissipation grille
Self‑check: Check rear ventilation is unblocked, confirm door fully closed
Solution: Clean grille; leak test & recharge refrigerant; replace faulty compressor
故障2:酒櫃時凍時唔凍,溫度反覆飄移
Fault 2: Intermittent cooling, unstable temperature reading
▼
原因:溫度感應器老化、風扇循環異常、門封漏冷
用戶自檢:觀察門膠條是否有縫隙,內籠風扇有無轉動
處理:更換溫度感應器;維修循環風扇;替換老化門封膠條
Cause: Aged temperature sensor, circulation fan fault, door seal cold leakage
Self‑check: Inspect door gasket gaps, check inner fan rotation
Solution: Replace sensor; repair circulation fan; renew door seal gasket
故障3:Vinorich 酒櫃開機完全唔著機,毫無反應
Fault 3: No power, unit completely dead
▼
原因:電源板故障、保險絲燒毀、電路接線鬆脫
用戶自檢:插座測試有冇電,電源插頭是否插穩
處理:檢查更換保險絲;維修電源主板;重接鬆脫線路
Cause: Power board fault, blown fuse, loose wiring
Self‑check: Test wall socket, confirm plug fully seated
Solution: Replace fuse; repair power mainboard; re‑secure loose connections
故障4:顯示屏黑屏、完全唔亮,但機器仍運轉
Fault 4: Display screen black, machine still running
▼
原因:顯示面板故障、接觸線鬆動、主板供電異常
用戶自檢:重新斷電重啟 5 分鐘再開機測試
處理:重新插接排線;維修或更換觸控顯示面板
Cause: Display panel defect, loose ribbon cable, mainboard power supply anomaly
Self‑check: Power off 5 minutes then restart
Solution: Re‑seat ribbon cable; repair or replace touch‑display panel
故障5:觸控面板按鍵無反應,無法調校溫度
Fault 5: Touch panel no response, cannot adjust temperature
▼
原因:觸摸面板受潮老化、主板控制模組損壞
用戶自檢:抹乾面板表面水氣,斷電重啟測試
處理:清潔檢查排線;必要更換整套觸控面板
Cause: Moisture‑damaged touch panel, faulty control module
Self‑check: Wipe surface moisture, power‑cycle unit
Solution: Inspect & clean ribbon cable; replace full touch‑panel assembly if needed
故障6:酒櫃不斷發出嗶嗶報警聲
Fault 6: Continuous beep alarm sound
▼
原因:門未關妥、溫度超標、故障代碼觸發警報
用戶自檢:關緊櫃門,查看屏幕有冇彈出錯誤代碼
處理:排除門關閉問題;讀取故障代碼維修對應零件
Cause: Door ajar, over‑temperature, error‑code trigger
Self‑check: Fully close door, check screen for error codes
Solution: Resolve door‑closing issue; diagnose parts according to error code
故障7:雙溫區酒櫃一邊凍、另一邊唔凍
Fault 7: Dual‑zone cooler: one side cold, other side no cooling
▼
原因:分區風扇損壞、擋風隔板移位、控溫感應器故障
用戶自檢:檢查內籠擋板有冇被酒瓶擋住出風口
處理:維修分區循環風扇;更換對應溫度感應器
Cause: Damaged zone fan, baffle displacement, zone‑sensor failure
Self‑check: Check wine bottles are not blocking air outlets & baffles
Solution: Repair zone‑circulation fan; replace faulty temperature sensor
故障8:Vinorich 酒櫃內部結冰、蒸發器結厚霜
Fault 8: Internal ice build‑up, heavy frost on evaporator
▼
原因:除霜系統失效、門封漏氣、濕度過高
用戶自檢:停機解凍,檢查門膠條有冇漏冷氣
處理:維修除霜感應器;更換門封膠圈
Cause: Defrost‑system failure, door‑gasket air leakage, high ambient humidity
Self‑check: Power‑off to defrost, inspect door gasket cold‑leakage
Solution: Repair defrost sensor; replace door‑seal gasket
故障9:酒櫃底部滴水、機內漏水積水
Fault 9: Water dripping at bottom, internal water pooling
▼
原因:排水孔堵塞、排水管脫落、凝水盤滿溢
用戶自檢:查看底部接水盤是否水滿,清理排水孔異物
處理:疏通排水管路;重新安裝脫落排水管
Cause: Drain hole clogged, drain pipe dislodged, overflowing condensate tray
Self‑check: Check water‑tray full status, clear drain hole debris
Solution: Unblock drain pipeline; re‑install detached drain tube
故障10:運行噪音大、機身震動,嘈吵擾人
Fault 10: Loud running noise & heavy vibration
▼
原因:壓縮機腳膠老化、風扇葉片碰殼、零件鬆動
用戶自檢:檢查酒櫃是否擺放水平,背後有冇牆面碰撞
處理:更換減震膠腳;維修更換故障風扇馬達
Cause: Aged compressor rubber mount, fan‑blade collision, loose internal parts
Self‑check: Confirm unit sits level, check rear‑wall collision
Solution: Renew anti‑vibration feet; repair / replace faulty fan motor
故障11:櫃門關不緊,容易彈開
Fault 11: Door cannot close tightly, pops open easily
▼
原因:門鉸磨損、門封膠條變形老化
用戶自檢:用紙張夾在門縫測試,紙可輕易抽出即漏冷
處理:調校門鉸;更換全新門封膠條
Cause: Worn door hinge, deformed aged door gasket
Self‑check: Paper‑strip door‑seal test; paper pulls out easily = cold‑leakage
Solution: Adjust door hinge; install brand‑new door‑seal gasket
故障12:酒櫃外殼發熱嚴重
Fault 12: Outer cabinet overheating
▼
原因:散熱位被封死、環境溫度太高、連續長時間運轉
用戶自檢:確保機身四周預留 10cm 以上散熱空間
處理:清理散熱網塵埃;改善周邊通風環境
Cause: Blocked ventilation, high ambient temperature, long continuous runtime
Self‑check: Keep ≥10cm clearance around unit for heat dissipation
Solution: Clean dusty heat‑grille; improve surrounding ventilation
故障13:櫃內燈光不亮,其他功能正常
Fault 13: Interior light dead, other functions normal
▼
原因:LED 燈條燒壞、燈具接線鬆脫
用戶自檢:斷電後輕搖燈帶位置,重啟測試
處理:重新接駁線路;更換 LED 照明燈條
Cause: Burnt‑out LED strip, loose lamp wiring
Self‑check: Power‑off, gently nudge lamp strip, restart for test
Solution: Re‑connect wiring; replace LED light strip
故障14:機器跳掣,開機不久就斷電跳總掣
Fault 14: Unit trips main power breaker shortly after startup
▼
原因:壓縮機短路、電容損壞、電路受潮短路
用戶自檢:不要反覆重啟,避免擴大故障
處理:檢測壓縮機與啟動電容,更換損壞零件
Cause: Compressor short‑circuit, defective capacitor, moisture‑caused circuit short
Self‑check: Do NOT repeatedly restart to prevent further damage
Solution: Test compressor & start‑capacitor; replace defective components
故障15:溫度顯示數字亂跳,讀數不準確
Fault 15: Temperature display flickers, inaccurate readings
▼
原因:溫度探頭損壞、主板訊號異常
用戶自檢:斷電重啟,觀察是否持續亂數
處理:更換溫度感應探頭;檢修主控板
Cause: Damaged temperature probe, mainboard signal anomaly
Self‑check: Power‑cycle unit, observe if flickering persists
Solution: Replace temperature probe; inspect & repair main control board
故障16:嵌入式 Vinorich 酒櫃製冷效果變差
Fault 16: Built‑in Vinorich wine cooler poor cooling performance
▼
原因:櫃體封死散熱空間、通風位被傢俬阻擋
用戶自檢:檢查櫃體上下後方通風口是否被遮蓋
處理:釋放散熱空間;清潔內置散熱模組
Cause: Enclosed installation blocks heat‑dissipation, furniture covers vents
Self‑check: Check top/rear/bottom ventilation openings are not covered
Solution: Free‑up ventilation clearance; clean internal heat‑dissipation module
故障17:酒櫃不停機 24 小時長期運轉
Fault 17: Wine cooler runs 24‑hours non‑stop
▼
原因:門封漏冷、設定溫度過低、感應器失效
用戶自檢:適當調高設定溫度,檢查櫃門密封
處理:更換門封膠;替換故障溫度感應器
Cause: Door‑seal cold‑leakage, set‑temp too low, failed sensor
Self‑check: Raise set‑temperature moderately, inspect door sealing
Solution: Renew door gasket; replace defective temperature sensor
故障18:出現故障代碼 E1/E2 等錯誤碼
Fault 18: Error codes E1 / E2 displayed
▼
原因:對應感應器、風扇或主板故障
用戶自檢:斷電 5‑10 分鐘重啟,看是否消除代碼
處理:對應代碼排查零件,更換損壞組件
Cause: Related sensor, fan or mainboard malfunction
Self‑check: Power‑off 5‑10 minutes then restart to test code clearing
Solution: Troubleshoot per error‑code; replace defective components
故障19:櫃內濕度異常,酒瓶標籤發霉
Fault 19: Abnormal humidity, wine labels grow mould
▼
原因:除濕模組異常、門頻繁開關、環境濕度太高
用戶自檢:減少頻繁開門,檢查門密封狀態
處理:維修控濕零件;檢查除霜系統運作
Cause: Dehumidification module fault, frequent door‑opening, high ambient humidity
Self‑check: Reduce frequent door‑opening, inspect door‑seal condition
Solution: Repair humidity‑control parts; verify defrost‑system function
故障20:機器有運轉聲,但完全沒有冷風吹出
Fault 20: Unit hums/runs, zero cold‑air output
▼
原因:循環風扇馬達燒毀、風扇卡到異物
用戶自檢:輕聽內籠有冇風扇轉動聲音
處理:清理異物;維修或更換內循環風扇馬達
Cause: Burnt‑out circulation‑fan motor, foreign object jams fan wheel
Self‑check: Listen carefully for inner‑fan spinning noise
Solution: Clear obstructions; repair or replace inner‑circulation fan motor