駿弘電器維修

答：多為電源保險絲燒斷、電源線鬆脫、插座接觸不良或主板故障。檢查家中電源、插座及電源線；保險絲燒斷或主板損壞需更換零件。

Answer: Usually caused by a blown fuse, loose power cord, poor socket contact, or mainboard failure. Check the power supply, socket, and power cord. Replace the fuse or mainboard if damaged.

答：風輪被油污卡阻、啟動電容損壞或電機燒毀。先清理風輪油污；電容或電機故障需專業更換。

Answer: The fan wheel is blocked by grease, the starting capacitor is damaged, or the motor is burned. Clean the fan wheel first. Replace the capacitor or motor if faulty.

答：濾網積油堵塞、安裝高度過高、排風管過長 / 彎曲過多或止回閥卡滯。定期清洗濾網；調低安裝高度、整理排風管或修復止回閥。

Answer: Grease filter is clogged, installation height is too high, ducting is too long/bent, or the check valve is stuck. Clean the filter regularly; adjust height, simplify ducting, or repair the check valve.

答：風輪積油失衡、電機軸承磨損、機體安裝鬆動或風葉變形。清理風輪油污、緊固機體；軸承或風葉損壞需更換。

Answer: Unbalanced fan wheel (grease), worn motor bearing, loose mounting, or deformed blade. Clean the fan wheel and tighten the unit. Replace bearings or blade if damaged.

答：觸控面板受潮、按鍵老化或控制板排線鬆動。吹乾面板潮氣、重插排線；面板損壞需更換。

Answer: Touch panel moisture damage, worn buttons, or loose control cable. Dry the panel and reconnect the cable. Replace the panel if faulty.

答：濾網安裝不到位、排風管密封不良、止回閥漏氣或機體傾斜。重新安裝濾網、密封管路；調平機體或更換止回閥。

Answer: Improper filter installation, duct leakage, check valve air leakage, or unbalanced unit. Reinstall the filter, seal ducts; level the unit or replace the check valve.

答：風速開關故障、檔位電路接觸不良或控制板損壞。檢查開關與線路；更換故障開關或控制板。

Answer: Faulty speed switch, poor circuit contact, or damaged control board. Check the switch and wiring. Replace the switch or board if faulty.

答：清洗水泵堵塞、水管鬆脫、噴嘴油污堵塞或控制模塊故障。疏通水泵與噴嘴、重插水管；模塊損壞需更換。

Answer: Clogged wash pump, loose water pipe, blocked nozzle, or faulty control module. Clean the pump/nozzles and reconnect the pipe. Replace the module if damaged。

多為電源保險絲燒斷、電源板變壓器損壞、插座接觸不良，檢查供電更換電源板即可修復。

多是溫度傳感器異常、線圈盤溫度過高、散熱風扇卡死，更換熱敏電阻清理風道就能解決。

散熱不良、風扇轉速不足、面板過熱保護啟動，清理油污灰塵更換散熱風扇恢復正常。

觸摸按鍵板受潮老化、控制面板排線鬆動，更換觸摸按鍵面板重插排線即可。

加熱管燒毀、溫控器斷路、高溫安全保險跳斷，更換發熱管與復位溫控即可修復。

水流量感應器靈敏度下降、進水壓力不均、恆溫主板失靈，清洗水流開關或調節水壓。

機體積塵散熱差、超溫保護啟動、熱熔保險老化，清理內部灰塵更換過熱保護配件。

答：內部水垢堵塞蒸氣喉管、水泵故障或水箱未到位。水垢輕微可用檸檬酸 / 白醋清洗；嚴重需疏通喉管或更換水泵、水箱感應器。

Answer: Limescale clogging steam pipe, faulty water pump or improperly inserted water tank. Minor limescale can be cleaned with citric acid/vinegar; severe cases require unclogging or replacing pump/tank sensor。

答：爐腔 / 蒸發盤溫度過高、溫度傳感器短路或散熱不良。清理风道、檢查傳感器線路，損壞需更換熱敏電阻。

Answer: Oven cavity/evaporation tray overheating, temperature sensor short circuit or poor ventilation. Clean air duct, check sensor wiring; replace thermistor if damaged。